Equally ideal for broadcast studios, voiceover artists, and podcasters, this UNCUCO Kit features the Neumann BCM 104 large-diaphragm condenser microphone, an adjustable table-mounted mic boom with a 12″ fixed horizontal arm, a removable foam windscreen, and a balanced XLR mic cable. The BCM 104’s cardioid polar pattern, gentle presence boost, internal pad and high-pass switches, and integrated pop screen allow it to communicate clear and crisp speech quality. Being a condenser mic, the BCM 104 requires 48V phantom power for operation. Once the mic boom is installed on a desk or table, the BCM 104 can be easily attached, then connected to your mixer using the supplied XLR cable.Neumann BCM-104 – Large Diaphragm Condenser Broadcast MicrophoneThe BCM-104 Large Diaphragm Condenser Broadcast Microphone from Neumann features a large-diaphragm, cardioid condenser capsule. It has a frequency response that is flat up to 3 kHz and then gradually boosted in the higher frequencies. If required, internal switches can be used to compensate for the proximity effect and to reduce the sensitivity by 14 dB.

The microphone headgrille twists off for quick cleaning. In front of the capsule, mounted on a frame holder, a fine gauze serves as a built-in popscreen. The microphone has an elastic mount against structure-borne noise, that is compatible with standard broadcast-segment microphone arms.

The microphone headgrille houses the K 04 large-diaphragm capsule, which has a flat frequency response up to 3 kHz. Higher frequencies have an increased presence up to 2 dB. Since the above-mentioned microphone characteristics are obtained without the use of resonance effects, the microphone features excellent transient response and transmits all transient phenomena of music and speech without any coloration.

A pop screen not only prevents the occurrence of plosive pop noises in vocal recordings, but also efficiently prevents unwanted particles, from respiratory moisture, nicotine, to food remnants, from settling on the diaphragm. The pop screen can be removed for cleaning without the use of tools.

Instead of a transformer to couple the microphone output to the supply voltage, the BCM-104 has an electronic circuit which, like a transformer, provides for good common mode rejection. Interference induced in the balanced modulation line is thus suppressed effectively. With a very low self-noise of 7 dB(A), and an overload capability extending to 138 dB SPL, the BCM-104 has a dynamic range of 131 dB (A-weighted).

The BCM-104 amplifier has a linear operation down to 20 Hz. An active filter efficiently suppresses signals below this frequency. In order to compensate for the proximity effect, an electronic high-pass filter, activated by a switch, is built into the microphone. This filter reduces frequencies below 100 Hz by 12 dB/octave. A 14 dB pre-attenuation switch is provided in order to adjust the sensitivity, if necessary, to circuits designed for dynamic microphones. But this will increase the self-noise accordingly. Both switches are located inside the microphone housing, since they will normally be operated only once, when the broadcasting facility is set up.

The preferred mode of operation is to suspend the BCM-104 from a standard studio boom arm. A thread adapter to fit different connector threads is included. In order to provide protection from structure-borne noise, both the capsule and the microphone in its mount are elastically suspended.Large-diaphragm condenser capsuleCardioid directional characteristicIntegrated pop protection and elastic suspensionMechanical compatibility with standard studio boom armsHigh-pass and pre-attenuation internal switchesWhatsApp:+8615989288128 , UNCUCO Radio / TV Studio Equipment. , 615104084834O.C. White ProBoom Ultima Gen2 Ultralow-Profile Adjustable Mic BoomPerfect for podcasts, interviews, and show hosts, the?O.C. White?ProBoom Ultima Gen2 Ultralow-Profile Adjustable Mic Boom?lets you achieve optimal microphone positioning while maintaining sight of your computer monitor and guests. Its ultralow-profile design utilizes a 12″ fixed horizontal arm to keep it close to your table/desk.The mic boom provides a maximum reach of 29″ and a weight capacity of up to five pounds, ensuring that it can safely and conveniently accommodate your favorite microphone. It features a 13mm mounting stud and includes a 13mm machined table bushing and comes with all necessary tools for proper installation and adjustment.29″ reach12″ fixed horizontal arm5 lb maximum weight capacity13mm mounting studBlack and charcoal finishIncludes all necessary tools for adjustment and installationMachined table bushing (13mm ID) includedMachined table bushing requires one drilled 7/8″ (0.875″) clearance holeNeumann WS47 Windscreen for D-01 Microphone (Black)Neumann’s WS47 Windscreen for D-01 Microphone? (Black) is an open-cell polyurethane foam which attenuates close-range sounds, wind, and fast movements of the microphone boom. The wind noise attenuation was measured without electrical filtering in a turbulent air stream traveling at 20 km/h, generated by a noiseless wind machine. Designed to FitThe WS47 windscreen is specifically designed to fit D-01 microphones made by Neumann.AttenuationWind noise attenuation is measured at 22 dB, while attenuation at 15 kHz is 3 dB.BlackThis particular windscreen comes in black so it perfectly matches your professional environment and equipment.WhatsApp:+8615989288128 , UNCUCO Radio / TV Studio Equipment. , 615104068261Kopul Premium Performance 3000 Series Neutrik XLR Male to XLR Female Microphone Cable (20′, Black)The black Kopul Premium Performance 3000 Series XLR Male to XLR Female Microphone Cable (20′) is designed to be an extremely quiet and flexible cable that is ideal for the most demanding live sound and performance applications. The cable is engineered to be durable and provide protection against EMI, RFI, and static noise. While the cable’s color-coding affords the ability to quickly differentiate between multiple connections on stage, it provides a pleasant aesthetic quality at the same time.Premium Performance 3000 Series cables are made from 24-AWG OFC copper wire that’s wrapped with PE insulation and a conductive PVC inner shield. A cotton-yarn inner layer helps reduce electrostatic and microphonic noise. The 95% dual-spiral shielding makes the cable resistant to EMI and RFI noise. The Neutrik XX silver connectors provide a high level of connectivity, and all the solder connections are shrink-wrapped for protection.95% dual-spiral shielding offers protection from EMI and RFI noiseTwin conductive PVC inner shielding provides 100% coverage of the core conductor. It helps keep the cable’s signal from radiating and affecting nearby cables and helps prevents external EMI from penetrating to the cable’s core24-AWG oxygen-free stranded copper inner core provides the best possible conductivityCotton yarn reduces electrostatic and microphonic noiseAll solder points shrink-wrapped for protectionNeutrik XX silver connectors offer high conductivityCaged type contact and improved ground contactWhatsApp:+8615989288128 , UNCUCO Radio / TV Studio Equipment. , 847628558304

Neumann BCM-104 – Large Diaphragm Condenser Broadcast Microphone SpecsMicrophoneOperating PrinciplePressure GradientCapsuleCondenserPolar PatternCardioidPad-14 dBPerformanceFrequency Range20 Hz to 20 kHz Maximum SPL138 dB SPL152 dB SPLImpedance50 OhmsLoad Impedance1000 OhmsSensitivity22 mV/Pa at 1 kHz into 1 KilohmsSignal-to-Noise Ratio76 dB CCIR87 dB A-WeightedTHD0.5% ConnectivityOutput Connectors (Analog)1 x XLR 3-PinPowerOperating Voltage48 V ¡À 4 VOperating Current Consumption3.2 mAPhysicalDimensions?: 2.5 x L: 3.35″ / ?: 63.5 x L: 85?mmWeight1.1?lb / 500?gPackaging InfoPackage Weight1.855 lbBox Dimensions (LxWxH)8.3 x 4.85 x 4.85″O.C. White ProBoom Ultima Gen2 Ultralow-Profile Adjustable Mic Boom SpecsPhysicalForm FactorStudio Microphone Arm without MountColorBlackTotal Reach29″ / 73.7?cmThread Size5/8″-27Arm Length12″ / 30.5?cm (Arm 1)Load Capacity5?lb / 2.3?kgIncluded CableNoneMounting Stud Diameter0.5″ / 13?mmMounting TypeSurface Mount (Included)Weight11?lb / 5?kgPackaging InfoPackage Weight5.14 lbBox Dimensions (LxWxH)19.1 x 12.3 x 3.9″Neumann WS47 Windscreen for D-01 Microphone (Black) SpecsMaterialFoamOuter Diameter4.72″ / 120?mmPackaging InfoPackage Weight0.2 lbBox Dimensions (LxWxH)10.4 x 4.8 x 4″Kopul Premium Performance 3000 Series Neutrik XLR Male to XLR Female Microphone Cable (20′, Black) SpecsCable Length20′ / 6.1?mShielding95% SpiralWire Gauge24 AWGContact PlatingSilverPackaging InfoPackage Weight0.765 lbBox Dimensions (LxWxH)11.6 x 11.2 x 1.15″S

Payment Method

We accept online payments via paypal, credit and debit cards. We also accept western union, money gram and bank transfer.

To order goods online and pay them via paypal, credit and debit cards, simply add your selected items to your basket, and proceed to the checkout, where you will be guided through the payment process.

Payment via PayPal:

1. You have your PayPal account, then choose the PayPal to complete the payment directly

2. If you want to use the PayPal payment, but you don’t have one PayPal account, please register one first.

Note: Choose the PayPal payment, you can choose your country currency, we accept all the currency.

Payment via Debit and Credit Card:

1. You click MasterCard, Visa Credit Card, American Express, Discover payment directly, you will be redirected to the PayPal website, then choose the payment method again, and fill in your card information to complete the payment.

2. You click the PayPal&Credit, you will be redirected to the PayPal website, the one is PayPal payment, the other one is Pay with Debit or Credit Card payment. Choose one to complete the payment.

Note: Your credit card will be charged upon placement of your order.

Payments via Western Union, Money Gram and Bank Transfer

If you would like to place your order, please contact us with the following information:

E-mail: service@uncuco.com

WhatsApp: +8615989288128

Your billing and delivery address.
Your full name, phone number and email address.
The list of items you'd like to purchase.
We will get back to you with a proforma invoice, and the directions for the final step to complete the direct deposit.

The payment needs to be verified by our in-house accounts department and goods will only be dispatched on their verification. Only once the funds have reflected in our bank account, will the goods be allowed to leave the store.
Please note that bank transfer transactions can take up to 4 business days to clear into our account. We will process your order as soon as your payment has cleared. To ensure a speedy turn around time, please notify us once you have made the deposit.

We offer cardholders the highest level of security in online shopping, irrespective of the type of card (credit or debit). All debit or credit card payments are processed via Activa System’s Secure Payment Gateway. All payment card information is entered exclusively on the bank’s 3D secure pages. We as the merchant do not store, have access to or sight of the payments card information. Should you select to pay with a payment card, you will therefore be redirected to secure pages administered by the Activa processing centre and a bank with which we have reached a card acceptance arrangement.

Verified by Visa & Mastercard
The Verified by Visa and MasterCard SecureCode trademarks displayed above allow each online purchase made with your payment card to receive additional protection via 3D Secure security protocols. 3D Secure is a unique service offered by MasterCard and Visa International that uses a One Time Pin (OTP) to protect a cardholder against unauthorized use of their card. Once activated, your card number cannot be used for online purchases at participating merchants without your One Time PIN (OTP). The OTP is sent to your cell phone during payment as the final step to complete the transaction.

SHIPPING AND DELIVERY

Shipping prices will be calculated at check-out, based on the weight of the goods, the country to which we are dispatching, and the shipping service you choose. If you place the order offline by email or phone, we will send you a proforma invoice including the shipping prices.

When will I receive my order?

The likely delivery timescale for orders will depend on the availability of the items you order, the delivery method you choose (where applicable) and the shipping destination country.

Delivery times can be calculated based on formula: Time to stock + 7days~15days ( The time shipping company needs deliver the products to address in your country)

Time to stock is the number of days we need to prepare your order for shipment or how long manufacturer or supplier needs to deliver the product to our warehouse.

Delivery tracking

We use DHL or Fedex or UPS or EMS express service for our deliveries. The tracking number will be sent to you by email as soon as we will ship the order. Please note that no information will be available for the tracking number until the shipping company has actually picked up the package. Please allow up to one business day for tracking information to become available. All deliveries require a signature.

Please note

We are only able to dispatch goods once payment has been received.
All orders are subject to approval by our verification department. We will notify you by phone or email should your order be delayed.
If, for any reason, we cannot supply a product you have ordered, we will contact you via email or phone and place your product/s on back-order once you have agreed you would like to wait. If you choose to put your order on back-order, we will provide you with personalized weekly updates and will notify you once your order has shipped. If one or more of your items is in stock and you are waiting on other item/s, you can have your order part shipped. A sales representative will keep you updated on the remaining portion of your order, and can provide tracking information for both shipments.